Product Application Chart

The System Three Resins Product Application Chart Use this chart to quickly pick the right product for your application need.
Download PDF 4k

---

End Rot Usage Brochure

Avoid costly replacement and ineffective rot repairs with EndRot from System Three Resins. Utilizing the 4-part EndRot Wood Restoration System fungal decay is eliminated. Then the rot-damaged wood is repaired with state-of-the-art epoxies. This system is easy to use and is the only permanent solution to rot problems.
Download PDF 1855k

---

Borate Rod Usage Brochure

Technical literature on the use of Borate Rods. Borate Rods are easy, low-cost and EPA approved as a decay protection and prevention system for wood. They have an appearance similar to glass rods and are available in a variety of sizes for a wide range of applications. Borate Rods are molded from fused; water-diffusible borates which are internationally recognized as an effective and well established wood preservative. Borates also effectively control termites, carpenter ants, a variety of beetles, and many other wood boring insects. They are user friendly and environmentally acceptable. Borates are highly toxic to fungal decay and many insects at concentrations that are not poisonous to humans or other mammals.
Download PDF 814k

---

Clear Finishing Of Outdoor Wood

For many years builders of wooden boats have used a combination of two-part epoxy resins and marine spar varnishes to make "furniture quality" clear-finished watercraft. That these boats look good after several years of outdoor exposure is testament to the synergistic effect of using these products together.
Download PDF 824k

---

Paint Literature

System Three manufactures a waterborne two-part epoxy primer and a linear polyurethane topcoat. Since these products thin and clean up with water they are less hazardous and less costly to use than their solvent-containing cousins. Because they are non-combustible they can be used where flammable solvent-based paints cannot. Once cured, the combination is water and chemical-resistant, and will offer maximum protection from sun and weather, for watercraft and many other projects. The primer has corrosion-resistance properties, while the topcoat contains ultra-violet light absorbers, to give it extra durability. Used as a clear finish without the primer, it can beautify and protect wood from discoloration and degradation.
Download PDF 480k

---

Composite Cored Boat Construction

A paper presented at the 1986 annual meeting of the Society of Plastics Industry titled Two Phase Epoxy Systems for Composite Cored Boat Construction will furnish the interested reader with a detailed discussion of the concepts behind the development of Phase Two. Tables 1 & 2 of that paper give the physical testing data for the “neat” resin along with laminate test data. It is not necessary, however to understand the concepts behind Phase Two in order to properly use it. Rest assured that it is a highly tested epoxy system for wet lay-up work and is far superior to polyester, vinyl ester or other epoxy laminating resins existing today.
Download PDF 48k

---

Using Phase Two Epoxy Resin

Phase Two is an epoxy resin system especially designed for building composite boat hulls with foam, balsa or honeycomb cores. It achieves an optimum balance of mechanical and toughness properties by utilizing two-phase morphology. Like other high performance resins, Phase Two requires a mild post heat cure prior to placing the part in service.
Download PDF 120k

---

Methods And Tips For Applying Mirrorcoat

This brochure provides tips and techniques for using Mirrorcoat to produce beautiful projects.
Download PDF 48k