u-TAH Cartridges

RSS

Simplicity in epoxy adhesive use has finally arrived! Just drop a System Three u-TAH™ cartridge into a conventional caulking gun, add a mixer tip and squeeze and apply. What could be easier? Only need a little bit and don't want to use a tip? Then squeeze out some into a cup, mix and apply. In either case the cartridge properly measures the resin and hardener and can never get the ratio wrong. After you're done put the cap back on and the cartridge is ready to go whenever you next need it. Four different adhesives to choose from: QuickCure 5T-88 Structural AdhesiveSilverTip GelMagic, and SA-2100 

Full Cartridge

 

This cartridge has two chambers, one behind the other. When the back plunger reaches the middle of the cartridge, the cartridge is empty. u-TAH is a trademark of TAH Industries, Inc.

Previous Post Next Post

  • STR Staff
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields