S-1 Sealer

Product Description

S-1 is a two-part Clear Penetrating Epoxy Sealer. Mixed at a simple 1:1 ratio S-1 is extremely effective at prolonging the service life of all woods, concrete, metals and fiberglass reinforced polyester.

S-1 is ready to use with no thinning required. It displays excellent wetting properties on most surfaces. S-1 has a long pot life and can be applied with a brush, roller or spray equipment. It is completely waterproof and suitable for use above or below the waterline. S-1 is a superb undercoat primer for most paints and clear finishes featuring strong adhesion to most substrates with minimal surface preparation.

S-1 does not require sanding between coats if recoat time is less than 24 hours. It is resistant to salt air, mild acids, alkalis, chemicals and solvents. S-1 is not recommended for gas tanks containing unleaded gasoline.

Simple 1:1 mix ratio
Ready-to-use viscosity, no thinning required
Excellent wetting properties on most surfaces
Applies by brush, roller, or spray
Long pot life
Waterproof
Strong adhesion to most substrates with minimal surface preparation
Non-brittle even at extremely low temperatures
No sanding required between coats up to 24 hours
Resistant to salt air and water, and mild acids, alkalis, chemicals and solvents (Not unleaded gasoline-proof).

NOTE: We are unable to ship S-1 to zip codes that fall within the South Coast Air Quality Management District (SCAQMD). The SCAQMD includes all of Orange County; and the non-desert regions of Los Angeles and Los Angeles County, San Bernardino County, and Riverside County.

2 Pint

2 Quart

2 Gallon

10 Gallon

$ 44.95

Mix Ratio by Volume	100:100
Mix Ratio by Weight	100:94
Total Solids	50%
Mixed Viscosity	100 cps
Mixed Color	Clear
Application Temperature Range	59°F to 104°F (15°C to 40°C)
Coverage (wet) @ 250 microns (10 mils)	300-350 ft2/Gal
Maximum Service Temperature	-4°F to 160°F (-20°C to 72°C)
Pot Life @ 70°F (21°C)	24 Hours
Tack-free Time @ 77°F (25°C)	4-6 Hours
Full Cure @ 77°F (25°C)	24-36 Hours

For Wood: S-1 seals effectively against moisture and oxygen, helping to protect against wood rot. It is ideal for yacht interiors, shelving, cabinets and furniture. For Concrete: S-1 is an excellent moisture barrier for concrete surfaces. For Metals: S-1 helps to prevent oxidation and chemical exposure effects including staining and tarnish. For FRP (fiberglass): Coat polyester laminates with S-1 to provide complete moisture resistance that the fiberglass by itself cannot provide. Use as a first sealer step in gelcoat blister repair, after the blisters have been ground out.

SDS Part A | SDS Part B

Technical Data Sheet

Notes:

Add System Three Epoxy Paste Pigments up to 10% of the Part A Resin to make colored S-1 Sealer.

S-1 contains flammable, hazardous, petroleum solvents and must be handled more carefully than our other solvent-free products.

Available Colors:

Clear. We offer epoxy dispersed pigments in black, white, red, yellow, blue, brown, and green so you can make your own colored epoxy.

Comments:

S-1 Sealer ships as hazardous and will incur additional charges when shipped via air. Ground shipments generally do not have additional hazard charges. We will contact you with the details of any additional charges before shipping your order.